Today I'll show you how to make a mini taser also known as shockeador. It can be used to good ends, for example, supports an integrated test whether x volts or for ill, for example to give a kick to the colo for all the nonsense he says and put it on the bus (ATZEQUIA TOTAL FAIL), you can not .
What we need is:
- a plug, ie a circular box with one leg and a mechanism with two screws to attach a cable.
- a 1N4004 diode on, has to endure at least 311 volts in reverse.
- A / A 311 volt capacitors that support or read below. Many
- caution and care when handling
To address this, we can grab and put two capacitors in series, so that each will be charged to Vpp / 2 -> 311 / 2 = 155 volts, which is considerably less than maximum voltage.
To load we can use this schematic:
After plugging at 0 seconds (R * C is almost zero) each capacitor is charged to 155 Volts. In my case
charged to V * C = 155 * 220 * 10 ^ -6 = 0.0341 C.
If you touch the capacitor against the skin, whereas the average strength of the skin as 10K, the current insurance will be about nothing 155/10K = 15mA and power dissipation by the body than 2.4 W.
This is enough to kill you. Whereas
Taw = 220uF * 10K = 2.2s, the capacitor is discharged after 5 Taw -> 10 seconds. This value is very high and, considering the average response time of the body of 200 ms and the minimum voltage that is felt is about 50Volts, we use about 25 downloads without having to charge the capacitor again.
0 comments:
Post a Comment